IFB Appliances Elite 5 KG - Manual (Page 7)

WATER INLET
DRAIN
PIPE
WATER INLET
DRAIN
PIPE
WATER
SUPPLY
STOP
LOCK
REDUCER
MACHINE
WATER
INLET
1/2 3/4
1. Remove Carton.
2. Remove top packing cover.
3. Remove side packing and plastic jacket.
4. Remove packing from the bottom of the
motor
5. Place the machine at the site at which it is to be
Installed, and put the rat mesh.
Unpacking
INSTALLATION
Pre Installation
1. It is mandatory to have a 16 amp. 3-pin 230V AC, 50Hz
electrical point with a 16 amp. MCB or Automatic short
circuit protection device within 1 meter of the machine.
Make sure it has proper earthing.
2. Fixed plumbing is recommended
for the machine. The water inlet
of the machine has a collar
with3/4”parallel internal threads.
The water supply point with an
exter nal 3/4” parallel thread
should be available within1 meter
of the machine’s location.
3. Two options on the water inlet and
drain pipe connection are shown.
In case these possibilities do not
exist for the drain pipe, please
arrange an additional length of
pipe.
4. Please inform our service centre for installation and demonstration
of the machine once the points mentioned above have been
completed.
8
r Avoid the machine coming in contact with floor cleaning
chemicals.*
r Do not wash or spray water over the switch or control panel.
r Do not allow children/pets to play with the machine.
r Do not wash shoes or utensils in the machine.
r Keep machine away from fire or heat.
r IFB will not be responsible if the user uses accessories not
manufactured or recommended by IFB.
r Take care when draining hot washing solution.
r Door always become very hot during washing at higher
temperatures. Keep children away from the appliance while it is in
use.
*Exposure can lead to rusting/corrosion.
37
SPECIAL NOTE
ONLY USE A DETERGENT RECOMMENDED FOR FRONT
LOADING WASHING MACHINES. A DETERGENT WHICH FOAMS
EXCESSIVELY CAN DAMAGE THE MOTOR AND DETERIORATE
THE RINSE QUALITY.
INSTALL MACHINE IN A ROOM WITH ADEQUATE VENTILATION.
AVOID A ROOM WITH NO WINDOWS. THE BACK OF THE
MACHINE SHOULD BE AT LEAST 4 INCHES (100 mm )AWAY
FROM THE WALL.
IF YOU USE A COVER OR TABLE CLOTH ON THE TOP LID, MAKE
SURE THAT THE VENTILATION SLOTS AT THE BACK ARE NOT
COVERED OR BLOCKED. THIS PRECAUTION WILL PROLONG
THE LIFE OF ELECTRICAL AND RUBBER COMPONENTS.