IFB Appliances Elite 5 KG - Manual (Page 9)

16 AMPS
X
X
WATER INLET
DRAIN
PIPE
WATER INLET
DRAIN
PIPE
Water Inlet
1. Connect inlet hose to water tap/line.
2. Do not connect machine to a hot water
supply.
Water Outlet
1. A drain pump is provided in the machine to
pump out used water.
2. The end of the outlet should be placed near a
drain. If necessary, it can be placed over the
edge of a sink at a maximum height of 1 mt.
from the floor level.
3. Allow free flow of water from the outlet pipe.
Electrical Connection
r Check that the electrical line take the required
load.
r Connect to a 230V, 50Hz single phase AC
supply. The appliance must be positioned so
that the plug is accessible.
r Machine must be earthed properly before
operation. This can be done by using a 3 - pin
plug and a properly earthed operated socket
of 16 Ampere rating.
r If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order to
avoid a hazard. It should not be stretched
when connected to the main socket.
10
MACHINE DOES NOT START.
q
Check position of programme selector knob
q Check water supply
q Porthole door not closed properly
q Indicator lamp not glowing
MACHINE DOES NOT SPIN / CLOTHES REMAIN WET.
q
Check if the No Spin button is pressed.
q water not drained out completely
q
q
q
MOTOR NOISE
It is normal for noises to be heard while motor is running.
However wash load, belt tension and motor mounting bolt
should be checked for specified limits.
PUMP NOISE
It is normal for noises to be heard from the pump during the start-
up and final stage of draining.
Unblanced load ( Divide the load in two halfs and spin
each load using exclusive spin program with desired
spin speed or add smaller articles of laundry to
balance the load & repeat the spin cycle.)
Excessive detergent / Foam
Load is too small.
35