Invacare GET-U-UP LIFT - Manual (Page 14)

SECTION 3—OPERATION
Get-U-Up ™ Lift 14 Part No 1148115
Operating the Lift
NOTE: For this procedure, refer to FIGURE 3.1.
Opening the Legs
1. Stand at the rear of the lift and grasp the shifter handle in one‐hand and place the opposite hand on the steering handle of the
mast for balance. Refer to Details “A” and “B”.
2. Push the shifter handle to your right to release the lock pin from its mounting hole.
3. Turn the handle clockwise until you are able to secure the lock pin into the opposite mounting hole to fully open the legs of
the base. Refer to Detail “C”.
NOTE: The lock pin MUST insert into its mounting hole in the socket assembly to lock the legs in the full open position. The shifter handle will
be in the vertical position and parallel with the mast assembly.
ƽ WARNING
If the shifter handle is NOT vertical, the lock pin is NOT seated in the socket assembly. DO NOT use
the lift until the lock pin is properly seated and locked in place or injury and/or damage may occur.
Closing the Legs
1. Stand at the rear of the lift and grasp the shifter handle in one‐hand.
2. Place the opposite hand on the steering handle of the mast for balance. Refer to Details “A” and “B”.
3. Push the shifter handle to your right to release the lock pin from its mounting hole.
4. Turn the handle counter‐clockwise until you are able to secure the lock pin into the opposite mounting hole to close the legs
of the base. Refer to Detail “C”.
FIGURE 3.1 Opening/Closing the Legs
Base
Closed
Base
Open
Shifter Handle Shifter Handle
Locked
DETAIL “A”
DETAIL “B”
DETAIL “C”
Shifter
Handle
Shifter
Handle
Lock Pin
Mounting
Hole
Steering
Handle
Steering
Handle
Mast
Mast