Standing procedure, Section 6—using lift as a standing aid, Ƽ warning – Invacare GET-U-UP LIFT User Manual

Page 23

Advertising
background image

SECTION 6—USING THE PATIENT LIFT AS A STANDING AID

Part No 1148115

23

Get-U-Up

Lift

SECTION 6—USING THE PATIENT LIFT AS A STANDING
AID

NOTE: For this procedure, refer to FIGURE 6.1.
NOTE: The Get‐U‐Up lift can be used as an aid to lift a person from 
a seated to a standing position. A minimum of two caregivers is 
required for this procedure.
NOTE: Invacare recommends that two assistants be used for all 
lifting preparation and transferring to/from procedures; however, our 
equipment will permit proper operation by one assistant. The use of 
one assistant is based on the evaluation of the health care professional 
for each individual case. 

Standing Procedure

1.

Ensure that the patient is capable of walking.

2.

Fold the footplate toward the mast.

3.

Use the adjustment pins to move the kneepad to a 
comfortable position.

4.

Ensure that the patient is in a sitting position to begin the 
procedure.

A. If the patient is in bed and requires assistance to come 

to a sitting position, raise the back of the bed.

B. Place the lift over the bed with the lift arms angled 

toward the patient.

C. Instruct the patient to grasp the lift arms.

D. As the lift arms are raised, the patient should move 

legs to the side of the bed until a sitting position on the 
side of the bed is assumed.

NOTE: The caregivers should assist as needed.

E. Pull the lift away as needed to accommodate the 

patient’s feet and legs over the side of the bed.

5.

With one caregiver on each side of the patient, place a gait 
belt on the patient.

6.

Ensure that the patient is wearing shoes with skid‐proof 
soles.

7.

If the patient is on the bed, raise the bed (if possible) while 
ensuring that the patient’s feet remain on the floor.

8.

If a walker is to be used, place the walker in front of the 
patient.

9.

Advance the lift toward the patient so that the patient can 
easily reach the lift arms.

10. Instruct the patient to grasp the lift arms.
11. Ensure that the patient’s feet are directly under them.
12. Begin raising the lift arms.
13. On a count of three, instruct the patient to pull and 

stand‐up while the caregivers support with the gait belt.

ƽ WARNING

DO NOT lift the patient.

14. Remove the lift to allow the patient to walk.

FIGURE 6.1 Standing Procedure

Note: The upper adjustment pins are typically used for shorter 
individuals. The lower adjustment pins are typically used for 
taller individuals.

Adjustment Pin

Mast

Footplate

Base

Kneepad

Post

Lift Arm

Lift Arm

Advertising