iLive IJ328-IB - Manual (Page 9)

9
Playing a CD+G Disc
Programming a CD or CD+G Disc
Step 1:
Press the Power Button to turn the unit on.
Step 2:
load the CD+G disc into the unit’s CD drive.
Step 3:
adjust the Source Dial to CDG.
Step 4:
Press the Play/Pause Button to play the loaded disc.
Step 5:
Plug in the included microphone to the Mic 1 Connection. adjust the
on/off Switch on the microphone to the on position.
• If feedback noise is present, move the microphone away from the unit
and/or reduce the microphone’s volume.
Step 6:
adjust the Volume Dial to adjust the volume of audio output from the
speakers. adjust the Microphone Volume Dial to set the volume of a
connected microphone.
Step 7:
Turn the AVC Select Dial to Vocal.
Step 8:
Use the AVC Dial to adjust the balance between the music and vocals.
Step 9:
Press the Play/Pause Button to play or pause the loaded CD+G.
Step 1:
Press the Power Button to turn the unit on.
Step 2:
load the CD or CD+G into the unit’s CD drive.
Step 3:
adjust the Source Dial to CDG.
Step 4:
Press the Program Button to begin programming the disc.
• The Program Indicator Light will illuminate red.
Step 5:
Select a CD or CD+G track using the Skip/Search Buttons.
Step 6:
once the desired track is selected, press the Program Button.
Step 7:
Repeat Step 5-6 until all of the desired tracks are programmed. (19 max)
Step 8:
Press the Play/Pause Button to beging playing the programmed tracks.
IJ328-IB.indd 9 7/10/2008 2:21:42 PM