Intel SG-81 User Manual
Sg-80 series
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Introduction
- Hardware Setup
- CPU Socket
- System Memory
- Connectors, Headers, and Switches
- ATX Power Connectors (ATX_POWER, ATX12V)
- FAN Connectors (CPUFAN, SYSFAN, PWRFAN)
- CMOS Memory Clearing Header (CCMOS)
- Front Panel Switches & Indicators Connection Headers (PANEL1)
- Additional USB Port Connection Header (USB3, USB4)
- Front Panel Audio Connection Header (FPIO-AUDIO1)
- Accelerated Graphics Port Slot (AGP1)
- Internal Audio Source Connectors (CD1, AUX1)
- Floppy Disk Drive Connector (FDC)
- IDE Disk Drive Connectors (IDE1, IDE2)
- Serial ATA connectors (SATA1, SATA2)
- External I/O Panel
- BIOS Setup
- About the Setup Utility
- Using BIOS
- Standard CMOS Features
- Advanced BIOS Features
- Thermal Management
- TM2 Bus Ratio
- TM2 Bus VID
- Limit CPUID MaxVal
- NX BIOS Control
- CPU L3 Cache (Enabled)
- Hyper-Threading Technology (Enabled)
- Quick Power On Self Test (Enabled)
- First/Second/Third Boot Device (Floppy/Hard Disk/CDROM)
- Boot Other Device (Enabled)
- Swap Floppy Drive [Disabled]
- Boot Up Floppy Seek (Disabled)
- Boot Up NumLock Status (On)
- ATA 66/100 IDE Cable Msg. (Enabled)
- Security Option (Setup)
- Small Logo(EPA) Show
- Advanced Chipset Features
- Integrated Peripherals
- Internal PCI/IDE (Both)
- IDE DMA Transfer Access (Enabled)
- IDE Burst Mode (Enabled)
- OnChip SATA Controller (Enabled)
- OnChip USB Controller (Enabled)
- OnChip AC97 Controller (Enabled)
- OnChip LAN Controller (Enabled)
- LAN Boot ROM (Disabled)
- Onboard FDC Controller (Enabled)
- Onboard Serial Port 1 (3F8/IRQ4)
- Onboard Parallel Port (378/IRQ7)
- Onboard 1394 Device (Enabled)
- Init Display First (PCI Slot)
- Power Management Setup
- PnP/PCI Configurations
- PC Health Status
- Frequency Control
- Load Fail-Safe Defaults Option
- Load Optimized Defaults Option
- Set Password
- Save & Exit Setup Option
- Exit Without Saving
- Driver Installation