IBM 8260 - Manual (Page 11)

Ÿ
Make sure you can reach the TFTP server by entering:
PING <ip address of the TFTP server>
(Stop PING by entering: Ctrl+C)
Ÿ
Start the download inband procedure by entering:
DOWNLOAD INBAND
When prompted, type "Y" to confirm.
Ÿ
Wait for successful termination of the download operation. The message Download
successful is displayed.
This may also be checked by displaying the TFTP last transfer result with the command:
"SHOW TFTP".
The command "SHOW DEVICE" displays the new BOOT code version which will become
active after an A-CPSW reset.
It should display: v.3.1.9.
If you have only one A-CPSW module go to step 6.
If you were upgrading your backup A-CPSW module go to step
6.
2.5 Step 5: Make the backup A-CPSW active
If you have a redundant A-CPSW make the backup one active by entering on the active
A-CPSW:
Ÿ
SET DEVICE ROLE SECONDARY
Ÿ
SAVE ALL
Ÿ RESET ATM_SUBSYSTEM
Ÿ
Log in as the Administrator on the A-CPSW console
The hub will reset and the backup A-CPSW will become active. GO TO STEP 2.
2.6 Step 6: Activate the new A-CPSW microcodes and the
new FPGA picocode
DO NOT PERFORM ANY SWAP BEFORE HAVING DOWNLOADED :
1 OPERATIONAL CODE
Installation Instructions
Copyright IBM Corp. 1998
Page 11 June 17 1998 EC : F34705 PN : 26L0227