IBM 8260 - Manual (Page 19)

--- ATM ADDRESS SETTING ---------------------------------------------------
After having completed the swap, the ATM address has been migrated to the
Node-0 ATM address, but the PNNI Summary Address was set to a default value.
So you need to enter the old ATM address again, with a new selector, by issuing the
following command :
o HUBb>set pnni node_0 atm_address:
39.99.99.99.99.99.99.00.00.77.77.01.02.00.00.82.60.01.02.01
o HUBb>SHOW FUTURE_PNNI NODE_0
Check your new ATM address.
o HUBb>COMMIT PNNI, the 8260 will be reset
The telnet session if any is broken.
Login as ADMINISTRATOR on the 8260 console.
o HUBb>SHOW PNNI NODE_0
Check your ATM address. It will display information about : LEVEL
ID, PEERGROUP ID, NODE ID.
---- PORT SETTING -----------------------------------------------------------------
After having completed the swap, the SSI port automatically became an enabled PNNI
port and the NNI port became a disabled IISP port, so you need to re-enable the IISP
port only:
1. Enable all your old NNI port (now IISP) as VOID port.
HUBb>SET PORT 3.1 ENABLE VOID
2. SETTING FOR UNI PORT. No change is needed for the port set as UNI
before the migration, the port 4.3 of HUBb has been left after migration as UNI
enabled.
--- VIRTUAL PATH CHANNELS SETTING (VPCS) : --------------------------------
Installation Instructions
Copyright IBM Corp. 1998
Page 19 June 17 1998 EC : F34705 PN : 26L0227