Invacare ICCG 6803A - Manual (Page 3)

Part No 1143214 3 ICCI Bed Rails and Accessories
FIGURE 2 Installing 6815A, 6816A and 6803A Bed Rails
7. Secure the bed rail to the mounting bracket with the two socket screws.
8. Head End Mounting Bracket Only - Position the crossmember between the two bed rails as shown in Detail “A” of
FIGURE 2 on page 3.
9. Repeat STEPS 3-7 to install the other bed rail on the opposite side.
Using the Epoxy Bed Rails
NOTE: For this procedure, refer to FIGURE 3.
1. Perform one of the following:
• Raising - Pull up on the bed rails while rotating
towards the head end of the bed until the bed
rail locks into place.
• Lowering - Pull up on the release lever and push
down on the bed rail while rotating towards the
foot end of the bed until the bed rail lowers into
place.
FIGURE 3 Using the Epoxy Bed Rails (Head End)
Release Lever
Towards the foot end of
the bed)
Bed Rail
Socket
Screw
Mounting
Bracket
Hex Bolt
Locknut Mattress
Deck
Attach Head End Crossmember Here
Bed Rail
Mattress
Deck
Mounting
Bracket
Socket Screw
DETAIL “B” - MOUNTING HOLE
LOCATION FOR MOUNTING
BRACKETS
DETAIL “A” - SIDE VIEW OF BED RAIL
Mounting Holes for
Mounting Bracket
Head End
Foot End
Mounting Pin
Crossmember (Head
End Only)
Mounting
Pin
Pivot Tube
Pivot
Tube
8th Mounting Hole
5th Mounting Holes
1st Mounting
Hole
1st
Mounting
Hole
Towards Foot End of
Bed
Bed Rail
Release Lever
Bed Rail in
Lowered Position