Installing/using nylasar bed rails – Invacare ICCG 6803A User Manual
Page 4
ICCI Bed Rails and Accessories
4
Part No 1143214
Installing/Using Nylasar Bed Rails
NOTE: The hardware shown in FIGURE 4 on page 4 is already assembled to the bars and latch arms before shipment. It is not
necessary to remove the hardware from the bolt or to remove the bolt from the bars or latch arms. Holding the bolt in place while
removing the hex nuts will prevent the hardware from becoming disassembled. In case of disassembly, refer to FIGURE 4 on page 4
for the correct placement of the hardware.
Installing the IH5748A Bed Rails
NOTE: For this procedure, refer to FIGURE 4 on page 4.
NOTE: Invacare recommends two people perform the following installation procedure. One person should hold the bed rail up
against the bed and one person should attach the rail to the bed.
1.
Position the bed rail on the bed frame with the release lever towards the foot end of the bed.
2.
Loosen and remove the hex nut from the latch arm at the foot end of the bed (Detail “B”).
3.
Carefully push the bolt through the mounting hole in the bed frame (Detail “B”).
4.
Loosely install the hex nut on the bolt to secure the latch arm to the bed frame (Detail “B”).
5.
Loosen and remove the hex nut from the bar closest to the latch arm (Detail “A”).
6.
Carefully push the bolt through the corresponding mounting hole in the bed frame (Detail “A”).
7.
Loosely install the hex nut on the bolt to secure the bar to the bed frame (Detail “A”).
8.
Repeat STEPS 5-7 for the remaining bars.
9.
Securely tighten all bolts and hex nuts securing the bars and the foot end latch arm to the bed frame. Torque to
100-150 inch-pounds.
FIGURE 4 Installing/Using Nylasar Bed Rails - Installing the IH5748A Bed Rails
Using the IH5748A Bed Rails
NOTE: For this procedure, refer to FIGURE 5.
1.
Perform one of the following:
•
Raising - Lift up on the bed rail until the rail
locks into place.
•
Lowering - Press in on the release lever and
push down on the rail.
FIGURE 5 Using the IH5748A Bed Rails
Release Lever
Spacer
DETAIL “B” - LATCH ARM HARDWARE
Bar
Bolt
Hex Nut
Latch Arm
Spacer
Bed
Frame
Bars
Bed Frame
Refer to Detail “A”
Refer to Detail “B”
Rubber
Bushing
Bar
Bearing
Bolt
Bed
Frame
Washer
DETAIL “A” - BAR HARDWARE
Hex
Nut
Spacer
Spacer
Bearing
Foot End
of Bed
Foot End of Bed
Release Lever
Bed Rail