Invacare ICCG 6803A - Manual (Page 6)

ICCI Bed Rails and Accessories 6 Part No 1143214
FIGURE 7 Installing the IHRAILTS-DLX Positioning Device
Using the IHRAILTS-DLX Positioning Device
NOTE: For this procedure, refer to FIGURE 8.
1. Perform one of the following:
• Raising - Pull up on the positioning device while
rotating towards the head end of the bed until
the positioning device locks into place.
• Lowering - Pull up on the release lever and push
down on the positioning device while rotating
towards the foot end of the bed until the
positioning device lowers into place.
FIGURE 8 Using the IHRAILTS-DLX Positioning
Device
Changing the Head Board Mounting Position
NOTE: For this procedure, refer to FIGURE 9.
NOTE: When using bed rails 6815A, 6816A, 6803A or IHRAILTS - DLX in conjunction with an 80-inch mattress, the head board
mounting brackets MUST be adjusted.
1. Remove the two mounting screws that secure head board mounting bracket to the bed frame. See Detail “A”.
2. Secure the head board mounting bracket to the bed frame as shown in Detail “B” using two mounting screws and
locknuts. Securely tighten.
NOTE: Ensure mounting brackets are perpendicular to the floor.
3. Repeat STEPS 1-2 to install remaining head board mounting brackets.
Release Lever
(Towards the foot end
of the bed)
Mounting
Bracket
Hex Bolt
Locknut
Mattress Deck Attach Head End Crossmember Here
Pivot
Tube
IHRAILTS-DLX
Positioning Device
Washer
Retaining
Clip
Mounting Pin
IHRAILTS-DLX
Positioning Device
Mattress Deck
Mounting
Bracket
Pivot
Tube
Washer
Retaining Clip
Crossmember
Positioning Device Release Lever