Icom IC-F610 - Manual (Page 14)

9
2
OPERATION
r Push [PTT] to send the status message to the despatch-
er.
t When the status message has been successfully sent
out, ‘OK’ appears on the display.
D D Include Call
• After moving to the communication channel, you can
make an additional call to the other station for them join
in to the communication with you.
➥Make a call with a memory individual/group call or make
a call via the keypad on the communication channel to
start the Include call.
D D PTT Quick Call function
The Despatcher, Status message, Call Back memory
selected by function key or the currently selected memory
group (current group) can be called only by push [PTT].
■ Making a call via the keypad
Various calls can be made by the following keying sequences
via the keypad*.
*HM-100TN optional DTMF microphone is required.
**Turn the ‘DTMF Mic’ function in the ‘Common-Common’
menu of the cloning software to ‘Enable’ when using this
function. Please consult your dealer.
D D Individual Call;
• Individual call to a station having the same prefix and
fleet codes.
Enter an individual code via the keypad and then push [#].
The individual call will be started.
(e.g.) To call 200 2001 300 from 200 2001 200, enter
‘300#’.
• Individual Call to a station having the same prefix code
and a different fleet code.
Enter the fleet code plus the individual code via the key-
pad and then push [#]. The individual call will be started.
(e.g.) To call 200 2006 300 from 200 2001 200, enter
2006300#.
• Individual Call to a station having a different prefix
code.
Enter the prefix code plus the fleet code plus the individual
code via the keypad and then push [#]. The individual call
will be started.
(e.g.) To call 211 2006 300 from 200 2001 200, enter
2112006300#.
NOTE: Instead of pushing [#], push [PTT] can be also make
the call.
IC-F610_MPT-2.qxd 05.5.10 1:00 PM Page 14 (1,1)