Icom IC-F610 - Manual (Page 26)

21
7
CONVENTIONAL MODE
‘ ‘ Conventional Mode operation
This transceiver has conventional mode capability. You can
use up to 32 pre-programmed conventional channels. These
channels can be selected with the [
] or [ ].
➥Push the [Mode] key assigned as the dealer programma-
ble key to toggle between Trunking mode and Conventional
mode. The transceiver memorizes the operating mode until
Mode key is pushed, even if the power is turned OFF.
NOTE: You must assign the [Mode] function to a dealer pro-
grammable key, both for the Trunking mode and the
Conventional mode in the key Assign screen of the cloning
software.
• CTCSS tone squelch function is available in the
Conventional mode. You can select the desired operating
channel and make a communication with [PTT].
• While the Conventional mode is selected, the [Clear/P 4 ]
key functions as [Monitor]. (Default setting.)
➥Pushing this key allows you to open the transceiver’s
squelch manually to check whether a channel is busy
or not.
‘ ‘ Programmable key assignment
Dealer programmable keys [P 0 ], [P 1 ], [P 2 ], [P 3 ], [P 4 ], [OP F0],
[OP F1], [OP F2], [∫ ∫], [√ √], [ ] and [ ] can be pro-
grammed for one of several functions by your Icom dealer.
In the following explanations, programmable function names
are bracketed; the specific switch used to activate the func-
tion depends on programming.
Conventional mode only;
[Monitor]
The monitor function allows you to open the transceiver’s
squelch manually to check whether a channel is busy or
not.
[CH Up]/[CH Down]
Push to select the operating channel.
[Simplex]
The Simplex function changes duplex channels to simplex
channels.
Simplex allows you to contact other portable transceivers
directly.
IC-F610_MPT-2.qxd 05.5.10 1:00 PM Page 26 (1,1)