Intel Express 5800 TM700 - Manual (Page 93)

TM700 User Guide - Upgrading Your System
4 - 33
The following picture shows a S-ATA cable. Black side goes to hard disk drive; blue
side goes to motherboard.
Figure 4 - 25 : S-ATA Cable
System Power Cables
Power cables come from the power supply and are attached to standard storage devices.
System power cables vary in length and provide connector sizes to accommodate a
variety of supported storage configurations. Power cable connectors are keyed to fit
only in the correct position. The following figures respectively show the power cable
connector for an IDE storage device and the power cable adaptor for a S-ATA device.
Figure 4 - 26 : IDE Storage Device Power Cable Connector
Figure 4 - 27 : S-ATA Storage Device Power Cable Adaptor
Cabling a CD/DVD-ROM or CD-RW Drive
All storage devices require power and IDE cable connections. Devices shipped with the
system are already connected.
The following procedure explains how to attach the cables to a CD/DVD-ROM or CD-
RW drive.
1. Connect the IDE cable connector (B) to the matching pins on the storage
device.