I-Tech Company WBX-6200F-V - Manual (Page 50)

41
Configuring the timer data area and printer base address next.
9A Return after setting timer and printer base address. Going to set
the RS-232 base address.
9B Returned after setting the RS-232 base address. Performing any
required initialization before the Coprocessor test next.
9C Required initialization before the Coprocessor test is over.
Initializing the
Coprocessor next.
9D Coprocessor initialized. Going to do any initialization after
Coprocessor test.
9E Initialization after the Coprocessor test is complete. Checking
the extended keyboard, keyboard ID, and Num Lock key next.
Issuing the keyboard ID command next.
A2 Displaying any soft errors next.
A3 Soft error display complete. Going to set keyboard typematic
rate.
A4 Keyboard typematic rate set. To program memory wait states.
A5 Memory wait state programming is over. Clearing the screen and
enabling parity and the NMI next.
A7 NMI and parity enabled. Performing any initialization required
before passing control to the adaptor ROM at E000 next.
A8 Initialization before passing control to the adaptor ROM at
E000h completed.
Passing control to the adaptor ROM at E000h next.
A9 Returned from adaptor ROM at E000h control. Performing any
initialization required after the E000 option ROM had control
next.
AA Initialization after E000 option ROM control has completed.
Displaying the system configuration next.
AB Building the multiprocessor table, if necessary.
AC Uncompressing the DMI data and initializing DMI POST next.
B0 The system configuration is displayed.
B1 Copying any code to specific areas.
00 Code copying to specific areas is done. Passing control to INT 19
h boot
loader next.
Flash BIOS Utility
Utilize AMI Flash BIOS programming utility to update on-board
BIOS for the future new BIOS version. Please contact your technical
window to get this utility if necessary.