JVC KD-MX3000R - Manual (Page 42)

42
REMOTE OPERATIONS
Before using the remote controller:
• Aim the remote controller directly at the remote sensor
on the main unit. Make sure there is no obstacle in
between.
• Do not expose the remote sensor to strong light (direct
sunlight or artificial lighting).
Remote sensor
1. Remove the battery case.
1) Push in the direction indicated by the arrow with
your right hand thumbnail.
2) Remove the battery case.
2. Replace the battery.
Put the battery in the case with the + side facing
upwards.
3. Return the battery case.
Insert again the battery case pushing until you hear a
clicking sound.
Installing the batteries
When it becomes necessary to bring the remote controller close to the remote sensor for it to
work, the battery is running low. At this point, the battery should be replaced. (Battery life is
about 1 year with normal use.)
WARNING:
• Store the batteries in a place which children cannot reach.
If a child accidentally swallows the battery, immediately consult a doctor.
• Do not recharge, short, disassemble or heat the batteries or dispose of in a fire.
Doing any of these things may cause the batteries to give off heat, crack or start a fire.
• Do not leave the batteries with other metallic materials.
Doing this may cause the batteries to give off heat, crack or start a fire.
• When throwing away or saving the batteries, wrap in tape and insulate; otherwise, , it may cause
the batteries to give off heat, crack or start a fire.
• Do not poke the batteries with tweezers or similar tools.
Doing this may cause the batteries to give off heat, crack or start a fire.
(back side)
1)
2)
Lithium coin battery
(product number:
CR2025)
(back side)
EN 42-43 KD-MX3000R [E]/2 7/27/98, 4:18 PM 42