JVC DPT 115 - Manual (Page 24)

5. Place the camera/lens/adapter plate on the pan and tilt as shown below. Position
camera/lens/adapter plate assembly such that balance point is located directly over center
point of the tilt axis of the pan and tilt head. Install mounting screw and washers at this
time, Do not tighten.
6. Move the camera/lens/adapter plate assembly to the right (forward) approximately 1/8
inch. The mounting screw should be tightened at this point. Remove the tape marking the
pivot point at this time.
JVC 3-CCD
BALANCE POINT
OF CAMERA & LENS
2/12/05 Document D0153
24