Jensen Hello Kitty KT2028A - Manual (Page 8)

7
5. A leader tape is provided at the beginning on each cassette. There is no recording on this area,
so it is necessary to let the tape run for about five seconds to clear the head.
6. Keep the tape head clean since a dirty head can cause distorted sound or improper tape speed.
Depress the Cassette Play Button (# 28) and use a small cotton swab with tape head cleaner or
alcohol to clean the tape head, capstan and pinch roller as shown below:
This CD Player provides the AUX IN JACK to enjoy your i-Pod, MP3 PLAYER MUSIC.
1. Connect the headphone jack of your external device and the AUX IN jack (18) located on the back
of this CD player. (The connection cable is not included.)
2. Turn on the CD player and it will enter the AUX function mode once the AUX IN jack is plugged.
3. Start to play your i-pod, MP3 player or other audio device.
4. Slowly adjust both the volume controls on your CD player and the external device.
5. Turn off your i-pod, MP3 player etc. when finish listening. Turn the CD player off and unplug the
AUX IN jack.
Remark: Once the AUX IN jack is plugged, the CD player will enter the AUX mode automatically
no matter the FUNCTION/POWER Switch (# 19) is in RADIO, TAPE or CD mode.
Remember to disconnect the connection cable from the CD player after use in order to
be able to listen to the RADIO, TAPE or CD player again.
Pinch Roller
Capstan
Playback Head
Tape Supply Reel
Tape Take-up Reel
CASSETTE TAPE OPERATING TIPS
1. High quality tapes are recommended to obtain maximum quality reproduction from recordings.
2. Tapes with playing time of 120 minutes (C-120) are not recommended because they contain
thinner and longer tape that has a greater chance to malfunction and jam, which may damage
the cassette mechanism.
3. To obtain good reproduction, the head should be cleaned after every 10 to 20 hours of use.
It is also recommended that the cassette be kept away from excessive heat or cold.
4. If there is slack in the tape, remove the slack prior to inserting the cassette. To remove the slack,
insert a pencil into the hub and rotate clockwise as shown below:
AUX IN OPERATION