JVC Everio GZ-HD320 - Manual (Page 66)


EN
Changing the Menu Settings
(Continued)
Menus Settings: [ ] = Factory-preset
RECORD BUTTON
Enables the recording button [REC]
on the LCD monitor.
OFF: Deactivates the function.
[ON]: Activates the function.
` QUICK RESTART
Enables the camcorder to start
up quickly when you turn off the
camcorder and then on again within
5 minutes by closing and opening
the LCD monitor.
OFF: Deactivates the function.
[ON]: If the LCD monitor is opened again within 5 minutes,
the camcorder starts quickly. The power consumption
used for the 5 minute period after the LCD monitor is
closed is approximately 1/3 that used during recording.
This enables you to save more power than leaving the
power on.
^ DROP DETECTION
Prevents damage to the HDD by
turning off the power automatically
when it is detected that the
camcorder dropped.
OFF: Deactivates the function.
[ON]: Activates the function.
To turn on the camcorder when the drop detection
worked, close the LCD monitor and open it again.
NOTE
•
The built-in hard disk of the camcorder may not be protected
even if the setting is [ON].
•
When recording/playback stops even if the camcorder is not
dropped, set the setting to [OFF] or set [REC MEDIA FOR
VIDEO] to [SD]. (Z p. 68)
] REMOTE
Turns on/off reception of the
operation signal from the remote
control.
OFF: Does not receive the signal from the remote control.
[ON]: Enables operation with the remote control.
_ AUTO FINALIZE
Sets the DVD to a readable state.
OFF: Makes created DVDs recordable (not playable on
device other than the camcorder).
[ON]: Finalizes created DVDs so that they can be played
back on DVD burner.
NOTE
•
When you play back a DVD created when [OFF] is set on
DVD burner, select [FINALIZE] on the DVD creation screen.
(Z p. 49)
•
When you create two or more DVDs at the same time, other
than the last DVD is finalized automatically even if the setting
is [OFF].
UPDATE
Updates and improves the system
software.
YES: Performs this function.
[NO]: Cancels this function.
NOTE
Information about obtaining system update will be made
available on the JVC’s web site.
Z FACTORY PRESET
Returns all the camcorder settings to
their default values.
YES: Performs this function.
[NO]: Returns to the menu screen without executing reset.