JVC Everio GZ-HD320 - Manual (Page 70)

0
EN
Troubleshooting
(Continued)
Trouble Action
Recor
ding
Recording cannot be
performed.
•
Slide the mode switch to select the desired mode ( ! or # ).
Vertical lines appear on
recorded images.
•
Such a phenomenon occurs when shooting a subject illuminated
by bright light. This is not a malfunction.
Recording stops by
itself.
•
If the camcorder temperature increases, REC flashes in the LCD
monitor and recording stops automatically to protect the HDD.
Turn off the camcorder, wait for a while, and start recording again.
•
Move away from a place where the camcorder is affected by
excessive sound or vibration (such as a concert hall).
•
A malfunction may occur in the HDD of the camcorder. In this
case, record to a microSD card.
•
Insert a commercially available microSD card, and set each of
the [REC MEDIA FOR VIDEO] and [REC MEDIA FOR IMAGE] to
[SD].
•
Recording stops automatically after 12 hours of continuous
recording.
The recorded subject is
too dark.
•
Use backlight compensation.
•
Set [GAIN UP] to [AGC] or [AUTO].
•
Use [NIGHT] from scene select.
•
Set the brightness to the [+] side.
The recorded subject is
too bright.
•
Set the backlight compensation to [OFF] if it is being used.
Set the brightness to the [–] side.
Digital zoom does not
work.
•
Change [ZOOM] to [80X / DIGITAL] or [200X / DIGITAL].
•
Digital zoom is not available in the still image recording mode.
The focus is not
adjusted automatically.
•
Wipe the lens with lens cleaning cloth.
•
If you are recording in a dark place or a subject that has no
contrast between dark and light, adjust the focus manually.
The color looks strange.
(Too bluish, too reddish,
etc)
•
Set [WB] in [MANUAL SETTING] appropriately to the light source.
•
Select [MWB] in [WB] while holding a sheet of plain white paper
in front of the camcorder so that the white paper fills the screen.
Keep touching OK until the B indicator appears.
White balance setting
cannot be activated.
•
This cannot be used if [SEPIA] or [MONOTONE] are selected as
effects.
•
Do not use [TWILIGHT] from scene select.
The continuous shooting
speed is slow.
•
The continuous shooting speed will drop after continuous shots.
• Continuous shooting speed may drop depending on the recording
media or under certain recording conditions.
Band of bright light
appears on the LCD
monitor.
•
This occurs when there is a bright light source near the
camcorder. This is not a malfunction. Change the direction of the
camcorder to prevent the light source comes into view.
Mosaic-type noise
occurs when recording
scenes with fast
moving or with extreme
changing in brightness.
•
Record videos with high quality mode, such as UXP or XP mode.