Juniper Networks NETSCREEN 208 - Manual (Page 22)

Juniper Networks NetScreen Release Notes
ScreenOS 5.0.0r9-FIPS P/N 093-1638-000, Rev. A Page 22 of 42
• 02384 – The device failed if you connected an Ethernet cable to the untrust
interface in the v1-untrust zone while the device was in transparent mode.
• 02383 – Under some circumstances, the OSPF routing instance could not
build an adjacency because its memory buffer was not large enough to
handle large databases.
• 02379 – You could not establish the Phase II portion of a VPN tunnel when
you referenced a custom service that had spaces in its name with no quote
marks around the string because ScreenOS did not recognize strings with
spaces without quotes around the string.
• 02377 – The Juniper NetScreen-200 did not always free up memory after
VPN tunnels closed, requiring a manual device reboot to recover.
• 02375 – The device was unable to detect and defend against a ping of death
attack and would fail when these types of packets arrived at the device.
• 02372 – You could not clear sessions on Juniper NetScreen-50 devices in an
active-passive environment in instances when the active device stopped
creating new sessions when the session table was full
.
• 02370 – When you manually created a VPN tunnel in an NSRP environment
in the WebUI, using an extra comma in the key portion of the set vpn
command, the primary device failed while the backup device kept the old
configuration.
• 02368 – ScreenOS removed the quotation marks around the VPN name with
a space when you configured an NHTB value on an interface.
• 02364 – The device generated an unknown keyword error to the keyword all-
virtual-system when you tried to assign a new admin password to a VSYS.
• 02354 – Occasionally, the ScreenOS logging environment incorrectly
displayed unusual logs that indicated a hacker attacked the device. A typical
message that indicated a hacker was the following:
2004-02-11 11:45:22 system notif 00001 Address
_prefix_c0000000_2_p72_ for ip address 192.0.0.0 in zone V1-
Untrust has been deleted by netscreen via web from host
128.32.199.217 to 128.32.199.71:80 session
• 02336 – In an NSRP active-active environment, when the customer
disconnected all the cables from the HA1, HA2, and MGT interfaces on
either device, and they reconnected cables to the HA1 and HA2 interfaces,
the device rebooted.
• 02323 – When you ran FTP Put or Get commands to push or obtain data to
or from the device, the WebUI always indicated the device had a Deny action
in its policy even when the policy was configured to permit traffic.