Juniper Networks ERX-1410 User Manual
Erx edge routers installation and user guide
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Installation and User Guide
- About This Guide
- ERX System Overview
- Installing the ERX System
- Installing ERX Modules
- Cabling the ERX System
- Accessing the ERX System
- Powering Up the System
- Maintaining the ERX System
- Troubleshooting
- System Specifications
- Module Specifications
- Cable Pinouts
- Preparing Your Site
- Installing ERX System Software
- Overview
- Installing Software When a Firewall Exists
- Task 1: Obtain the Required Information
- Task 2: Access Privileged Exec Mode
- Task 3: Configure IP on an Interface
- Task 4: Mount the CD on the Network Host
- Task 5: Configure Access to the Network Host
- Task 6: Enable the FTP Server on the ERX System
- Task 7: Identify the Files to Transfer
- Task 8: Transfer Files to the User Space
- Task 9: Install Files on the System Space
- Task 10: Save the Current Configuration
- Task 11: Reboot the System
- Installing Software When a Firewall Does Not Exist
- Installing Software in Normal Operational Mode
- Task 1: Obtain the Required Information
- Task 2: Access Privileged Exec Mode
- Task 3: Configure IP on an Interface
- Task 4: Configure Access to the Network Host
- Task 5: Mount the CD on the Network Host
- Task 6: Copy the Software Release File
- Task 7: Save the Current Configuration
- Task 8: Reboot the System
- Installing Software in Boot Mode
- Installing Software in Normal Operational Mode
- Copying Release Files from One ERX System to Another
- Upgrading Systems That Are Operating with Two SRP Modules
- Declaration of Conformity
- Index