Juniper Networks ERX-1410 User Manual
Page 180
Index
2
current (electrical) requirements A-2
customer support 1-xix
D
DCE status 8-4
Declaration of Conformity, EC F-2
detecting double-bit error 8-11
Device Management System, NMC-RX 1-11
diagnosing problems. See troubleshooting
diagnostic LEDs 8-3 to 8-9
dimensions of ERX system A-1
dissipation, heat A-1
distribution rack D-3
documentation set, Juniper Networks xvii
CD xviii
CD, using the xix
comments on xix
double-bit errors
detecting 8-11
troubleshooting 8-12
E
earth/ground connections 4-3
EC Declaration of Conformity F-2
EIA distribution rack. See distribution rack
electrical requirements A-2
environmental requirements A-1, D-2
ERX-1400 model 1-2
See also ERX-1400 series
See also ERX system
fan tray 1-15
front view 1-3
installation
rear view 1-4
slot identification and grouping 3-2
specifications A-1 to A-3
unpacking 2-1
See also ERX system
See also ERX-1440 series
See also ERX system
See also ERX 700 series
See also ERX system
fan tray 1-15
front view 1-5
installation
rear view 1-5
slot identification and grouping 3-3
specifications A-1 to A-3
unpacking 2-4
See also ERX system
See also ERX 700 series
See also ERX system
compatibility with modules B-1 to B-4
assigning IP address to 5-3, E-13
booting E-6, E-11, E-14
cabling 4-1 to 4-16, 4-17, D-7
connecting to earth/ground 4-3
dimensions A-1
hardware. See hardware
installing 2-1 to 2-10
installing components 7-1
installing software E-1
lifting 2-7, 2-8
maintenance 7-1
management access 1-11, 5-1 to 5-6
position in the network 1-6
powering up 6-1 to 6-4
safety guidelines 2-7, 3-6, 4-3, D-2
site planning D-1 to D-7
slot identification and grouping 3-2 to 3-4
specifications A-1 to A-3
troubleshooting 8-1 to 8-9
unpacking 2-1
Ethernet link 8-4, 8-9
Ethernet traffic 8-4
external timing ports 4-7
F
faceplate 3-5
FAIL LED 8-3
failure, fan 8-4, 8-8, 8-10
failures. See troubleshooting
FAN FAIL LED 8-4
FAN OK LED 8-4