John Lewis JLWFF1552 - Manual (Page 11)

11
A. Mains indicator light (green)
B. Button On/Off
C. Temperature setting button (+) (for warmer
temperatures)
D. Temperature display
E. Temperature setting button (-) (for colder
temperatures)
F. Temperature setting button (+) (for warmer
temperatures)
H I J K L
The wine cooler control panel
When the wine cooler is first
installed
Warning
Allow the appliance to stand for 2 hours after
installation.
Insert the plug into the wall socket.
Press On/Off.
The green mains indicator light illuminates.
Press either the “C“/“F“(+) or “E“/“H“ (-) buttons.
The temperature display switches over and the
DESIRED temperature currently set flashes on the
temperature display.
Set the required temperature by pressing the
“C“/“F“(+) or “E“/“H“ (-) buttons (see section
"Temperature setting buttons"). The temperature
display will immediately show the changed setting.
Each time the button is pressed the temperature is
adjusted by 1 °C.
Once the required temperature has been set, after a
short period (approx. 5 sec.) the temperature
display will change and again indicate the current
ACTUAL temperature inside the Wine Cooler.
The display will change from flashing to continuous
illumination.
Information! When the setting is changed, the
compressor does not start immediately if automatic
defrosting is currently taking place.
As the storage temperature within the Wine cooler
is reached quickly you can store beverage
immediately after switching on.
Important: If the wine cooler is switched off,
the door must be closed to ensure that the
freezer is working properly.
When switched off, the electronic control of
the appliance functions automatically and
periodically circulating the air to prevent
unpleasant smells and humidity within the
compartment.
Temperature setting buttons
The temperature is adjusted using the “C“/“F“(+) or
“E“/“H“ (-) buttons.These buttons are connected to
the temperature display.
The temperature display is switched over from the
display of the ACTUAL temperature (Temperature
display is illuminated) to the display of the DESIRED
temperature (Temperature display flashes) by
pressing one of the buttons,“C“/“F“(+) or “E“/“H“
(-).
Each time one of the two buttons is pressed again
the DESIRED temperature is adjusted by 1 °C. The
DESIRED temperature will be reached within 24
hours.
G. Temperature display
H. Temperature setting button (-) (for colder
temperatures)
I. Light Button “LIGHT”
J. LIGHT button
K. Alarm reset light
L. Door-Alarm OFF button