Sound adjustments, Adjusting the sound, English – JVC KD-LH1150 User Manual
Page 20
20
ENGLISH
SOUND ADJUSTMENTS
Adjusting the sound
You can adjust the sound characteristics to your
preference.
• “Vol Adj” setting is required for each source
except FM. Before starting “Vol Adj,” select an
appropriate source for which you want to make
an adjustment.
1
Select the item you want to adjust.
The next-step-operation
buttons start flashing.
Each time you press SEL
(select), the adjustable items
change as follows:
Indication
To do:
Range
Fad*
1
Adjust the front
R06 (Rear only)
and rear speaker
|
balance.
F06 (Front only)
Bal
Adjust the left
L06 (Left only)
and right speaker |
balance.
R06 (Right only)
Sub Out*
2
Adjust the
00 (min.)
subwoofer output
|
level and cutoff
12 (max.)
frequency level.
Low/Mid/High
Vol Adj*
3
Adjust and store
–12 (min.)
the input level
|
of each source.
+12 (max.)
*
1
If you are using a two-speaker system, set the fader
level to “00.”
*
2
Only for KD-LH1150:
This takes effect only when a subwoofer is
connected.
*
3
By adjusting the input level to match it to the FM
sound level, you will not need to adjust the volume
level each time you change the source. This
adjustment is memorized for each source except
FM.
2
Make adjustments.
• To adjust fader and balance—Fad, Bal:
You can make these two adjustments at
the same time, by referring to the
indication on the display.
• Press
5 (up) or ∞ (down)
to adjust the fader.
• Press
¢
or
4
to adjust the balance.
• To adjust subwoofer output—Sub Out:
(only for KD-LH1150)
You can also set an appropriate cutoff
frequency level according to the subwoofer
connected.
• Press
¢
or
4
to select “Low,”
“Mid,” or “High.”
Low:
Frequencies higher than 50 Hz are
cut off to the subwoofer.
Mid:
Frequencies higher than 80 Hz are
cut off to the subwoofer.
High: Frequencies higher than 115 Hz
are cut off to the subwoofer.
Fad (Fader)
Bal (Balance)
Vol Adj
(Volume Adjustment)
Canceled
Sub Out
(Subwoofer Output)
only for KD-LH1150
To decrease the level
To increase the level
Canceled
Only for KD-LH1150
EN20-23KD-LH1150_1100[J]f.p65
1/25/03, 11:18 AM
20