JVC DR-M100S - Manual (Page 63)

Masterpage:Right+
EN
63
Filename [M100SEK_10Subsidiary.fm]
SUBSIDIARY SETTINGS
OTHERS
8
AUTO TIMER ^ OFF / ON
This is the setting for engaging timer recording standby mode.
OFF :
Press TIMER j to engage timer recording standby mode.
ON :
Timer recording standby mode is automatically engaged when
the unit is turned off.
8
RESUME ^ OFF / ON / DISC RESUME
When this function is set to AONB or ADISC RESUMEB, you can use
the resume function.
OFF :
You cannot use the resume function.
ON :
The resume function works on the disc loaded on the unit.
DISC RESUME :
The unit retains a memory of the resume points of the last
30 discs played back, even though they have been ejected.
NOTE:
ADISC RESUMEB setting works on DVD VIDEO, VCD, SVCD and
finalised DVD-R/DVD-RW (Video mode) discs. For other types of
discs, the function under
AONB setting will be applied even if
ARESUMEB is set to ADISC RESUMEB.
Remote Control 1/2/3/4 Code Switching
The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of the four
codes (1, 2, 3 or 4). The remote control is preset to send code 3
signals because your unit is initially set to respond to code 3
signals. You can easily modify your unit to respond to code 1, 2 or
4 signals.
● Keep pressing SET UP down during step 1.
1
Press the number key A1B for 1, A2B for 2, A3B for 3 or A4B for 4 to
change the remote control code, then press ENTER.
2
Press A on the unit to turn off the unit.
3
Press I on the unit for over 5 seconds while the unit is turned
off. The code currently set appears on the front display panel.
4
Press o on the remote control to change the unit’s code. The
code currently set on the remote control blinks on the front
display panel for approximately 5 seconds, and is applied to the
unit.
Remote Control Functions
ENTER
SET UP
1-4
o
RAM/RW
I A
M100SEK_00.book Page 63 Tuesday, March 22, 2005 5:31 PM