JVC DR-M100S - Manual (Page 66)

Filename [M100SEK_10Subsidiary.fm]
Masterpage:Left+
66
EN
SUBSIDIARY SETTINGS
Your unit needs to memorise all necessary stations in channel
positions in order to record TV programmes. Auto Channel Set
automatically assigns all receivable stations in your area to call
them up by using the PR +/– buttons without going through any
vacant channels.
Auto Channel Set
1
Press SET UP to access the Main Menu screen.
2
Press selection keys to select AINITIAL SET UPB, then press
ENTER for confirmation.
3
Press selection keys to select AAUTO CH SETB, then press
ENTER for confirmation
● When you have connected the unit to a TV offering T-V Link via
a fully-wired 21-pin SCART cable (A pg. 17), the unit
automatically performs the Preset Download and the T-V LINK
screen will appear. (A pg. 20)
● The Auto Set screen appears, and remains on screen while the
unit searches for receivable stations.
4
After completing Auto Channel Set, press ENTER.
When Auto Channel Set is completed,
ASCAN COMPLETEDB
appears on screen
5
Press SET UP to complete the setting.
● Using the Confirmation screen, you can skip or add channel
positions, enter station names and perform other operations.
Refer to pages 67 - 68 for the procedures.
● Depending on reception conditions, the stations may not be
stored in order, and the station names may not be stored
correctly.
NOTES:
● Fine tuning is performed automatically during Auto Channel Set.
If you want to perform tuning manually, refer to
AFine-Tuning
Channels Already Stored B (A pg. 68).
● If you perform Auto Channel Set when the aerial cable is not
connected properly,
ASCAN COMPLETED-NO SIGNAL-B
appears on the TV screen in step 4. In such a case, make sure of
the aerial connection and press ENTER; Auto Channel Set will
start again.
Tuner Set
● Turn on the unit.
● Turn on the TV and select an input mode such as EXT1.
IMPORTANT:
Perform the following steps only if ^
^ Auto Channel Set has not been set correctly by Auto Set Up
or by Preset Download. (A pg. 18, 19)
^ you have moved to a different area or if a new station starts
broadcasting in your area.
SET UP
(FGDE)
ENTER
Selection Keys
IMPORTANT:
● In certain reception conditions, station names may not be
stored correctly, and Auto Guide Programme Number Set may
not work properly. When the Guide Programme numbers are
not set properly, the programme that you do not intended to
record will be timer recorded by the VIDEO Plus+ system of
the unit. When programming the timer using the VIDEO Plus+
system, be sure to check the desired channel is selected
correctly.
ACheck, Cancel And Change ProgrammesB
(A pg. 42)
● Your unit memorises all receivable stations even if reception of
some of them is poor. You can delete those stations with an
unacceptable picture from the list. (A pg. 67,
ADelete A
Channel B)
M100SEK_00.book Page 66 Tuesday, March 22, 2005 5:31 PM