Jet Tools M-628900 - Manual (Page 8)

8
Contents of the Shipping Carton
1. Sander
Assembly
1. Handwheel with Handle
1. TUF Tool
1. Abrasive Strip (wrapped on the drum)
1. Conveyor Belt (attached to the base)
1. Owner's Manual
1. Warranty Card
1. Hardware Bag (for attaching the Sander
to the Optional Open Stand) —
containing:
4. 3/8”-16x5/8” Hex Cap Screws
4. 3/8” Flat Washers
Read and understand the
entire contents of this manual
before attempting assembly or
operation of this drum sander.
Failure to comply may cause
serious injury.
Unpacking
1. Remove all the contents from the
shipping carton.
2. Report any damage to your distributor.
3. Do not discard any shipping material
until the sander has been assembled
and is running properly.
Assembly and Setup
If you purchased the optional Performax 10-20
Stand, refer to its assembly instructions before
proceeding with the drum and conveyor
assembly. Note: The figures shown in this
manual may display the Performax 10-20-Plus
Drum Sander with several optional accessories.
To purchase any of these accessories contact
your dealer.
1. Attach the handwheel (Figure 1, Item A)
to the height adjustment screw and
tighten.
Performax 10-20 Accessories
Stock #
Description
638004 Open Stand with Shelf
608005 Infeed/Outfeed Tables
98-0130 Caster Set (4) for Open Stand
60-0505 Abrasive cleaning stick
Figure 1
A