Jet Tools M-628900 - Manual (Page 9)

9
On/Off Switch
Before powering up the unit,
make sure all of the tools
used to assemble and adjust
the unit are removed and
accounted for. Make sure
your hands, loose clothing
and any other items that may
get caught are safely away
from the unit.
The On/Off Switch (Figure 2, Item A) is located
on the front of the sander. To turn the sander on,
pull the switch to the on position. To turn the
sander off, push the switch to the off position.
Switch Lock
The sander can be locked from unauthorized
use by locking the switch. To lock the switch:
1. Turn the switch to the off position and
disconnect the sander from the power
source.
2. Pull the key (Figure 2, Item B) out. The
switch cannot be turned on with the key
removed.
Should the key be removed
from the switch in the on
position, the switch can be
turned off but cannot be
turned back on.
3. To replace the key, slide the key into the
slot on the switch until it snaps.
Circuit Breaker
The sander is equipped with a motor protective
device (circuit breaker). The breaker will
automatically shut the sander off when
excessive current is consumed.
If the breaker is tripped, turn the sander off and
reset the circuit breaker by pressing the button
(Figure 2, Item C).
Be sure to turn the sander off
before resetting the circuit
breaker to avoid
unintentionally starting the
sander
Figure 2
A B C