JVC CompactFlash LYT0143-001A - Manual (Page 20)

20
EN
P LA Y OFF
Flash Shooting
Use the flash when the low light “ ” icon appears on-screen during indoor shooting or under low light.
1
Make sure that the Power Dial is set to “ A ”,
“ M ” or “ ”, then press the FLASH/TRANSFER
Button.
• The Flash Lamp starts blinking and the flash
begins charging.
When charging is complete, the Flash Lamp
stops blinking but stays lit, and the flash “ ”
icon appears on the LCD monitor.
• If no operation is performed while the flash
icon is displayed, the flash icon disappears.
When this occurs, press the FLASH/
TRANSFER Button again.
• To abort flash shooting before taking a
picture, press the FLASH/TRANSFER Button
again.
2
Aim the flash at the subject and press the
Shutter Release Button.
• The flash emits light and the Flash Lamp
turns off.
MENU Jog Dial
Power Dial
Lock Button
To take another shot with a flash . . .
.... repeat the above steps.
Flash Adjustment
The flash intensity can be increased or decreased by
2 steps. For details, see “Flash Adjustment”
(
੬
pg. 29).
NOTES:
● While the flash is charging, the LCD monitor turns
off to save power. This is not a malfunction. Once
the flash is charged after a few seconds, the LCD
monitor turns on again.
● When the batteries are nearly exhausted during
flash shooting, the power may turn off.
● During Self-Recording, the flash is not charged
and does not emit light.
● Since flash shooting consumes a large amount of
battery power, it is recommended to keep a spare
set of batteries nearby when you are planning to
take many photographs with the flash.
● When battery power weakens, the time it takes for
the Flash Lamp to light steadily increases, and
flash charging may be aborted. Before pressing
the Shutter Release Button, make sure the Flash
Lamp stays lit.
FLASH/TRANSFER Button Flash Lamp
Flash
BASIC OPERATION (cont.)