JVC CompactFlash LYT0143-001A - Manual (Page 8)

8
EN
1
Slide the battery cover (BATTERY) slightly to
open.
• The battery cover opens.
2
Insert batteries as indicated by the orientation
marking inside the battery cover.
3
Close the battery cover and slide it back.
• The battery cover is locked in the closed
position.
• Make sure the battery cover is closed
securely.
NOTES:
● Commercially-available LR6 (AA)-size nickel-
cadmium (Ni-Cd) or nickel-metal hydride (Ni-
MH) batteries can also be used. Ni-Cd or Ni-MH
batteries are more economical because they can
be recharged and used repeatedly. Be sure to read
their instructions.
● Inserting batteries in the incorrect direction may
cause them to leak.
GETTING STARTED
1 Open the battery cover by performing step 1
of “Loading Batteries” to the left.
2 Take out batteries by tilting the camera
slightly.
NOTES:
● Do not use manganese batteries as they do not
have sufficient energy to power this camera.
● If the batteries are not used for an extended
period, remove them from the camera to avoid
battery leakage, which can cause malfunctions to
occur.
● Since batteries become very hot after they are
exhausted, be careful when replacing them with
new ones.
● Replace the batteries when the battery power
remaining indicator displays the red mark.
Loading Batteries
Use LR6 (AA)-size dry cell batteries.
Unloading Batteries
BATTERY
Cover
1
2
3
green red
Hand Strap Attachment
1
Open the jack cover.
2
Thread the end of the hand strap through the
camera's eyelet, then thread the loop of the
hand strap through the end.
3
Close the cover.
Loop
1
2
3