Jenn-Air W10300219A - Manual (Page 11)

11
■ Route water supply line and drain hoses into the cabinet.
■ Slide dishwasher partway into the cabinet opening. Allow
for access to the electrical terminal box.
Connect Water Supply Line and Drain
Hoses
1. Connect water supply line to the water valve under the sink.
2. Slide clamps onto drain hoses (Figure A). Do not cut drain
hoses.
3. Push hose into drain connector until fully seated (Figure B).
Several “clicks” will be heard.
4. Slide clamp into position (figures C and D).
5. Connect the drain hose using one of the following options:
Option 1: Waste Disposer No Drain Air Gap
NOTE: This connection must be before the drain trap and at least
20" (50.8 cm) above the floor where the dishwasher will be
installed. It is recommended that the drain hose be looped up and
securely fastened to the underside of the counter.
Option 2: No Waste Disposer and Drain Air Gap
A. Hot water supply
A
A. For new construction, remove disposer plug.
B. Connect drain connector to waste disposer.
C. Tighten clamp.
A. Drain air gap
B. Drain hose connector
C. Waste
A B
C D
A C
B
B
A
C