Jenn-Air W10300219A - Manual (Page 4)

4
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Needed
Parts Needed
Parts Supplied
Check that all parts are included.
■ Pliers
■ Phillips screwdriver
■ Flat-blade screwdriver
■
³⁄₁₆" and ¼" nut drivers or
hex sockets
■ Measuring tape or ruler
■ 1½" hole saw bit
■ 10" adjustable wrench
■ Utility knife
■ Level
■ Cordless drill
■
¹⁄₈" drill bit
■ Security T-20 TORX ®†
driver (on some models)
A. 72" (182.9 cm) flexible water supply line
B. Zip tie
C. Appropriate sized UL Listed wire connectors (2)
A
B
C
†®TORX is a registered trademark of Acument Intellectual Properties, LLC
A. ³⁄₄" UL Listed/CSA Approved
strain relief
B. 1.25" hose clamp
C. Mounting bracket screws (8)
D. Unit mounting screws (4)
E. Drain hose connector
F. Mounting brackets (4)
G. Drain connector spring
clamps (2)
H. Trim strips (2)
I. Toe kick brackets (2)
J. Toe kick bracket screws (2)
K. Toe kick trim
L. Panel fasteners (on some
models) (2)
M. TORX ®† screws (on some
models) (10)
N. Drain hose
A
B
C D
E F
H
G I
J
K
L
M
N