Jenn-Air W10300219A - Manual (Page 18)

18
Install Panel Fasteners
1. Remove the 2 panel fasteners from the face of the inner door
of the drawer.
2. Screw the 2 panel fasteners into the panel fastener pilot holes
of the custom panel.
Mount the Custom Panel
Custom Decorative Panel Only
1. Remove the tape from the green ground wire on the custom
decorative panel. The end of the green ground wire is factory-
attached to the custom decorative panel.
2. Attach the ring connector end of the green ground wire on the
custom decorative panel to the ring connector and ground
screw on the dishwasher drawer intermediate panel.
Custom Decorative Panel or Custom Wood Panel
1. Mount the custom panel to the drawer by aligning the panel
fasteners to the 2 keyhole slots and insert the panel.
Custom Decorative Panel
Custom Wood Panel
2. To secure the custom panel onto the drawer, push the custom
panel down until the top of the custom panel is flush with the
top of the control panel.
3. Using the screws provided, secure the custom panel to the
inner door by screwing through the inner door and into the ¹⁄₈"
(3.2 mm) pilot holes.
A. Green ground wire
B. Ground screw
A
B