JVC TK-C625 - Manual (Page 12)

12
EN
Connections & Installation (continued)
Use twisted-pair cables for the connections.
●Duplex
When the camera is controlled using the full duplex protocol,
set the Switch 5 of the Setting switch to ON.
Four wires must be connected.
Example (connection with an RM-P2580)
●Simplex
When the camera is controlled using the simplex
transmission protocol, set the Switch 5 of the Setting switch
to ON.
Two wires must be connected.
Point-to-Point Communication System (continued)
RX +
RX -
TX +
TX -
TX +
TX -
RX +
RX -
Camera Controller
RX +
RX - TX +
TX -
TX +
TX -
RX +
RX -
A
B
C
D
A
B
C
D
Camera RM-P2580
RX +
RX -
TX +
TX -
Camera Controller
TK-C625.book Page 12 Thursday, March 31, 2005 4:20 PM