JVC HD-DH40000U - Manual (Page 16)

16
EN
Setting cable box input
channel & brand
After installation, set the cable box input channel and its
brand correctly; otherwise, the Controller cannot work
correctly.
1 Turn on cable box
Select a channel other than channel 9 on your
cable box.
2 Access Main Menu screen on VCR
Press MENU.
3 Access Cable Set Up screen
1 Press @ # to move
the arrow to
“TUNER SET UP”,
then press
fi or
OK.
2 Press @ # to move
the arrow to
“CABLE SET UP”,
then press
fi or OK.
4 Select cable box input channel
Press %fi to move
the arrow to “INPUT
CH”.
Your selection
depends on how your
cable box is
connected to your
VCR.
● If your cable box is connected to your VCR’s
ANTENNA IN terminal on the rear panel
Press
@ # until the channel number
representing the cable box’s output (ON CH2 –
ON CH9) appears on the screen.
● If your cable box is connected to your VCR’s
AUDIO/VIDEO IN connectors on the front panel
Press
@ # until “ON F-1” appears on the
screen.
● If your cable box is connected to your VCR’s
AUDIO/VIDEO IN (L-1) or AUDIO/VIDEO IN
(L-2) connectors on the rear panel
Press
@ # until “ON L-1” or “ON L-2” appears
on the screen.
● If you do not use a cable box
Press @ # until “OFF” appears on the screen.
VCR
TV
CABLE
/DBS
3 – 6
2 7
INITIAL SETTINGS (cont.)
FUNCTION SET UP INITIAL SET UP TUNER SET UP
THEN PRESS [OK]
DBS SET UP
SELECT WITH ARROW KEYS
SELECT
OK
EXIT
MENU
INPUT CH
BRAND 1
TEST MODE
OFF
TUNER SET CABLE SET UP
FUNCTION SET UP INITIAL SET UP TUNER SET UP
THEN PRESS [OK]
INPUT CH
BRAND 1
TEST MODE
OFF
SELECT WITH ARROW KEYS
SELECT
OK
EXIT
MENU
CABLE SET UP
● Turn on the VCR and the TV, and select the AV
mode on the TV.
● Set the VCR/TV/CABLE/DBS selector on the
Remote to “VCR”.
HM-DH40000U-EN15-20 1/22/3, 4:37 PM 16