JVC HD-DH40000U - Manual (Page 21)

EN
21
IN F-1
+
POWER
STOP/EJECT
( 7/0)
1 2
REW ( )
FF ( )
BASIC PLAYBACK AND RECORDING
Basic
Playback
This VCR can check the tape condition during playback
(and recording), and realizes the best possible pictures.
● This VCR can play back tapes that have been recorded
in D-VHS (MTP), S-VHS, S-VHS ET and VHS formats.
● When playing back a tape, this VCR automatically
identifies the recording format (D-VHS, S-VHS, S-VHS
ET or VHS).
● When you play back a tape recorded on this VCR, you
can use the Video Navigation function ( ੬ pg. 42).
1 Load a cassette
Make sure the window side is up, the rear label
side is facing you and the arrow on the front of
the cassette is pointing towards the VCR.
Do not apply too much pressure when inserting.
● The VCR turns on automatically.
● The tape will run for a few seconds while the
VCR searches for the tape number. If the tape
number is found, it will be shown on the TV
screen if “SUPERIMPOSE” is set to “ON”
(
੬ pg. 57).
● The counter is reset automatically, however, it
is not completely reset to “0:00:00”.
● If the cassette’s record safety tab has been
removed, playback begins automatically.
2 Start playback
Press PLAY ( 3 ).
● Recording speed is automatically detected.
● If “V. CALIBRATION” is set to “ON” (default
setting) and “PICTURE CONTROL” is set to
“AUTO”: (
੬ pg. 54), “VIDEO CALIBRATION”
appears on the screen, and this VCR checks the
tape condition during automatic tracking (only
cassettes recorded in the S-VHS, S-VHS ET or
VHS mode).
To stop playback
Press STOP ( 7 ) on the Remote or STOP/EJECT ( 7 / 0 )
on the front panel.
To rewind the tape (when it is not running)
Press REW ( 1 ).
To fast-forward (when it is not running)
Press FF ( ¡ ).
To eject the tape
Press STOP/EJECT ( 7 / 0 ) on the front panel when the
tape is not running.
● You can also eject the cassette when the VCR is turned
off.
To turn off the VCR
Press POWER.
VCR
TV
CABLE
/DBS
POWER
REW( 1)
2
FF( ¡)
STOP( 7)
● Turn on the VCR and the TV, and select the AV
mode on the TV.
● Set the VCR/TV/CABLE/DBS selector on the
Remote to “VCR”.
NOTES:
● When you use the Video Navigation function, operate the
VCR only after the tape number is detected; otherwise, you
cannot use the Video Navigation function.
● It will take a moment until the image appears when you play
back cut segments (segments for which recording was
continued after stopping or pausing) or segments for which
recording was switched from VHS mode (SP or EP) to D-VHS
mode.
● For details on LS5 mode, refer to “Notes on playback in LS5
mode” on page 22.
HM-DH40000U-EN21-33 5/8/3, 10:32 AM 21