Jet Tools JOB SITE TABLE SAW JBTS-10MJS - Manual (Page 26)

26
interfere with the cut if used on the left side
groove.
Referring to Figure 38:
1. Adjust the blade (A) to the desired angle, and
tighten the blade bevel lock knob.
2. Tighten the miter lock handle (C) at 90°.
3. Hold workpiece (B) firmly against the face of the
miter gauge throughout the cutting operation.
Figure 38
Compound Miter Crosscutting 0°~45° Blade Bevel
& 0°~45 Miter Angle
This sawing operation combines a miter angle with a
bevel angle.
Always work to the right side of
the blade during this type of cut. The miter
gauge must be in the right side groove because
the bevel angle may cause the blade guard to
interfere with the cut if used on the left side
groove.
1. Set the miter gauge (C) to the desired angle.
2. Place the miter gauge in the right side groove of
the table.
3. Set the blade (B) bevel to the desired bevel
angle and tighten the blade bevel lock knob.
4. Hold workpiece (A) firmly against the face of the
miter gauge throughout the cutting operation.
Figure 39
Mitering 0°~45° Miter Angle
This sawing operation is the same as crosscutting
except the miter gauge is locked at an angle other
than 90°.
1. Set the blade (B) to 0° bevel angle and tighten
the blade bevel lock knob.
2. Set the miter gauge (A) at the desired miter
angle and lock in position by tightening the miter
gauge locking handle.
3. Hold the workpiece (C) firmly against the face of
the miter gauge throughout the cutting
operation.
Figure 40
Using the Wood Facing on the Rip Fence
When performing some special cutting operations,
you can add a wood facing to either side of the rip
fence (C, Fig. 41).
1. Use a smooth straight 3/4 in. thick wood board
(A, Fig. 41) that is as long as the rip fence.
2. Attach the wood facing to the fence with wood
screws (B, Fig. 41) (not included) through the
holes in the fence. A wood fence should be used
when ripping material such as thin paneling to
prevent the material from catching between the
bottom of the fence and the table.
Figure 41
Dado Cuts
The maximum dado cut width is 13/16 in.
Only Stackable dado blades can
be used on this saw.
DO NOT use Adjustable or Wobble
type dadoes.
Referring to Figure 42: