Jet Tools JOB SITE TABLE SAW JBTS-10MJS User Manual

Page 27

Advertising
background image

27

1. Remove the saw blade and the blade guard for

dado cuts ONLY. Reinstall and realign blade
guard for all through- sawing operations. Install
a dado not exceeding 6 in. diameter and 13/16
in. width.

2. Install a dado table insert making sure that the

rear of the insert is flush with the table.

Note: A dado table insert is not included but can
be ordered (SN 707001) by calling the number
on the cover of this manual.

3. Instructions for operating the dado is packed

with the separately purchased dado set.

4. The arbor (B) on this saw restricts the maximum

width of the cut to 13/16 in.

5. It is not necessary to install the outside flange (A)

before threading on the arbor nut (C) for the
maximum 13/16 in. dado cuts. Make sure that the
arbor nut (C) is tight, and that at least one thread
of the arbor sticks out past the nut.

6. Use only the correct number of round outside

blades and inside chippers as shown in the dado
set’s instruction manual. Blade/chippers must
not exceed 13/16 in. total in width.

7. Check the saw to ensure that the dado will not

strike the housing, insert, or motor when in
operation.

For your own safety, always

replace the blade, blade guard assembly, and
table insert when you are finished with the dado
operation.

Figure 42

Advertising