Jabra GO 6430 - Manual (Page 19)

19
english
Jabra GO 6430 User manUal
hanGinG uP 6.5
to terminate a call when no calls are on hold, Tap the headset multifunction button. you can also terminate a call
using the native controls of your mobile phone or softphone. If you are using an unsupported softphone,
then you must always use the softphone’s native interface to hang up.
Figure 12: Hanging up
contRollinG the SPeakeR voluMe and MicRoPhone 6.6
the headset features a touch panel that is similar to the touch pad included with many laptop computers.
Use it to adjust the volume you hear in your headset and to mute/unmute the microphone.
- slide your finger up the touch panel (away from your mouth) to increase the volume.
- slide your finger down the touch panel to decrease the volume.
- double-tap on the touch panel to mute or unmute the microphone.
2 x
Figure 13: Using the volume strip and mute control
Note: a tone will sound to indicate each new volume setting; a double tone indicates that you have
reached maximum or minimum volume. you will also hear a soft tone in the headset to remind you when
microphone muting is active; this signal will repeat occasionally until you reactivate the microphone.
If you hang up while the microphone is muted, it will automatically be re-enabled the next time you place
or answer a call.