Jabra GO 6430 - Manual (Page 32)

32
english
Jabra GO 6430 User manUal
the JabRa link 350 uSb bluetooth adaPteR 9.
the Jabra lInK 350 Usb bluetooth adapter and travel Charger are included with the Jabra GO 6430 package; they
are available as accessories for all other Jabra GO solutions. this chapter explains how to use the Jabra lInK 350
Usb bluetooth adapter. this chapter explains how to use the travel Charger. see also Chapter 3: Product Overview
for detailed diagrams.
JabRa link 350 uSb bluetooth adaPteR diaGRaM 9.1
1. Activity indicators (LEDs)
2. USB plug
3. Multifunction button
LINK350
2
1
3
Figure 19: Jabra LINK 350 USB Bluetooth Adapter
PuRPoSe of the JabRa link 350 uSb bluetooth adaPteR 9.2
the Jabra lInK 350 Usb bluetooth adapter connects to your computer and communicates with your headset via
bluetooth. It provides the following features:
- basic bluetooth connection
- softphone control
- Wideband audio
- headset configuration
though it is also possible to pair your Jabra GO headset with any standard bluetooth device — including
bluetooth pC cards — this type of pairing provides only the basic connection (the first point listed above) and
you may also experience compatibility issues. softphone-control, wideband audio and headset-configuration
features require the Jabra lInK 350 Usb bluetooth adapter.
PaiRinG the JabRa link 350 uSb bluetooth adaPteR and headSet 9.3
the headset and Jabra lInK 350 Usb bluetooth adapter are already paired from the factory. the procedure given
below is only necessary if pairing is lost.
to pair your Jabra GO headset and Usb bluetooth adapter:
1. attach the Usb bluetooth adapter to your pC and turn on the pC (see also the section 4.4: Jabra LINK 350 USB
Bluetooth Adapter Setup and Connections).
2. put the Usb bluetooth adapter in pairing mode by pressing and holding its multifunction button for about
2 seconds — until its blue pairing led turns on and stays lit.
3. If your headset is currently turned on, turn it off by pressing and holding on its multifunction button for about
4 seconds — until its led gives three quick red flashes and then turns off.
4. put your (powered-off) headset in pairing mode by pressing and holding on its multifunction button for about
4 seconds — until its led lights a constant blue.
5. place the headset close to the Usb bluetooth adapter and wait for a few seconds. When pairing is successful,
you will see the following indicators:
- On the adapter: the led flashes blue quickly 5 times and turns off.
- On the headset: the led flashes blue 5 times and then turns off.