JVC 0397MKV*UN*VP - Manual (Page 26)

26
VIDEO CAPTURE (cont.)
AUTOMATIC CAPTURE
Automatic video capture is available only when a JLIP-compatible video source unit is con-
nected. There are two types of automatic capture: Program mode and Interval mode. You can
save time in either mode because, once the initial settings have been stored or you have decided
what pictures to capture, the subsequent capture process is carried out automatically.
PROGRAM CAPTURE
In the Program Capture mode, select the images you want to capture, and the JLIP Video
Capture Docking Station will automatically capture and transfer the images to your computer.
Preparation
•Make sure all units are properly connected
(
੬
p. 12).
•Insert a tape into the video source unit.
Click "Image Format" in "Set-up" and select
"Field Picture" in the Capture Mode
(
੬
p. 30).
1 Open the menu bar and click "Setup" —
"Capture Mode" — "Automatic".
•The "Automatic Transfer" window
appears.
2 Select data to be transferred.
•When you select "Index Image", index
image data (80 x 60 pixels) is trans-
ferred to your computer.
•When you select "Index & Full Image",
both the index image data (80 x 60
pixels) and full image data (768 x 552
pixels) are transferred to the computer.
3 Select "Program Capture" and click
"OK".
Set-up
Capture Mode
Image Format
Device Change
Initialize
ID Change
Counter Reset
Step by Step
Automatic
NOTES:
•Before transferring your images, make
sure that enough space is available on
your hard disk. For full image data
space requirements,
੬
p. 24.
•When transferring full image data using
the Bitmap image format (
9
.bmp), the
transfer takes a very long time, causing
the video source unit to stop playback
automatically.