JVC GR-DVP10 - Manual (Page 11)

EN
11
Master Page: Right
Using The Battery Pack
1
Align the battery pack’s two notches with the tabs
on the camcorder’s battery pack mount.
2
Insert the terminal end 1 of the battery pack into
the battery pack mount.
3
Firmly push the end 2 of the battery pack until it
locks into place.
To detach the battery pack...
While sliding down BATT. RELEASE, remove it.
NOTE:
When using the battery pack and the S/AV/Editing
cable, disconnect the S/AV/Editing cable first
(
੬ pg. 22), and then detach the battery pack.
Maximum continuous recording time
NOTES:
● Recording time is reduced significantly under the
following conditions:
• Zoom or Record-Standby mode is engaged
repeatedly.
• The LCD monitor is used repeatedly.
• The playback mode is engaged repeatedly.
● Before extended use, it is recommended that you
prepare enough battery packs to cover 3 times the
planned shooting time.
Using AC Power
1
Make sure you unplug the camcorder’s DC cord
from the AC Power Adapter/Charger.
2
Plug the AC Power Adapter/Charger’s power cord
into an AC outlet. The POWER indicator lights.
3
Attach the coupler part of the DC cord to the
camcorder’s battery pack mount.
4
Plug the DC cord to the DC OUT connector on
the AC Power Adapter/Charger.
NOTES:
● The provided AC Power Adapter/Charger features
automatic voltage selection in the AC range from
110 V to 240 V.
● For other notes, ੬ pg. 64.
Battery pack LCD monitor on Viewfinder on
BN-V107U 1 hr. 1 hr. 10 min.
BN-V114U
(optional)
2 hr. 2 hr. 20 min.
ATTENTION:
Before detaching the power source, make sure
that the camcorder’s power is turned off. Failure to
do so can result in a camcorder malfunction.
Notches
BATT. RELEASE
Switch
To AC outlet
To DC OUT
connector
Power cord
AC Power Adapter/
Charger
To battery pack mount
DC cord
POWER indicator
(red)
GETT
ING ST
AR
TED
GR-DVP10PAL.book Page 11 Tuesday, January 6, 2004 10:55 AM