JL Audio Stealthbox SB-GM-HUMRH2/12W6v2/TN - Manual (Page 2)

➔ ➔
➔ ➔ ➔
STEP 7: With the plastic trim out of the way,
remove the plastic inner wheel well.
STEP 11: Thread the supplied pair of socket ca
set screws into the enclosure, leaving 1/2” exposed.
Place the enclosure into place and firmly press
down.
Cont.
From
Previous
Page
Continued on Next Page ➔
➔
STEP 8: Rest the plastic inner wheel well on the
rear tire. Keep the trim and all the mounting hard-
ware together.
STEP 12: *CAUTION*
Before drilling, make sure that you are not going to
be drilling into any gas lines, brake lines, transmission
lines, electrical wiring, transfer case(4x4 vehicles) or
anything else that might cause a reduction in your
weekly pay. Always wear eye protection when
drilling.
With the use of a 1/2” drill bit and drill. Drill out the
floor at the impression on the wax square.
➔
STEP 13: Remove the wax square sheets from the
mounting area. STEP 14: Run speaker wire to the enclosure loca-
tion.
Also check the woofer for proper operation.
STEP 9: (Inside the vehicle) Cut and remove
the factory jute(sound deadening), from the
removed storage area, from STEP 5. STEP 10: Place the supplied pair of wax sheets
into place.
Remember to remove the rear paper backing, from
the wax sheets.
S B - G M - H U M R 2 / 1 2 W 6 v 2 , J L AU D I O, I n c 2 0 0 4 S h e e t S K U # 0 1 1 1 8 2 R ev i s i o n 8 / 5 / 2 0 0 4 Pa g e 2 w w w . j l a u d i o . c o m