JVC KD-G120 - Manual (Page 27)

9
3
Adjust the PSM item selected.
4
Repeat steps 2 and 3 to adjust other
PSM items if necessary.
5
Finish the procedure.
You can change PSM (Preferred Setting Mode)
items listed in the table that follows.
1
2
Select a PSM item.
Indications Selectable settings, [reference page]
DEMO
Display
demonstration
DEMO ON : [Initial]; Display demonstration will be activated automatically
if no operation is done for about 20 seconds, [5].
DEMO OFF : Cancels.
CLOCK H
Hour adjustment 1 – 12, [5]
[Initial: 1 (1:00)]
CLOCK M
Minute adjustment 00 – 59, [5]
[Initial: 00 (1:00)]
L/O MODE
Line output mode When connecting an amplifier or a subwoofer, set this correctly.
REAR
: [Initial]; Select if the REAR LINE OUT terminals are used for
connecting the speakers through an external amplifier.
WOOFER : Select if the REAR LINE OUT terminals are used for
connecting a subwoofer.
AMP GAIN
Amplifier gain
control
You can change the maximum volume level of this unit.
LOW PWR : VOL 00 – VOL 30 (Select this if the maximum power of the
speaker is less than 50 W to avoid damaging the speaker.)
HIGH PWR : [Initial]; VOL 00 – VOL 50
General settings — PSM
EN06-09_KD-G124_123[UI]f.indd 9 EN06-09_KD-G124_123[UI]f.indd 9 10/4/05 12:16:03 PM 10/4/05 12:16:03 PM