John Deere OMGX20927 - Manual (Page 21)

Assembly - 17
ASSEMBLY
Ass embly Identify Parts
Bag of Parts
Install Bagger Support Rod
MX10310
1. Fit tabs (G) on cargo mount bracket (E) into slots (H) on
mounting post (D).
2. Insert bagger support rod (A) between cargo mount
bracket and mounting post.
3. Insert round head bolt (F) through cargo mount bracket
and into hole (I) in mounting post.
4. Secure bolt with M8 lock nut (B) and flat washer (C).
Install Hopper Top and Bags
Assemble Hopper Top
NOTE: Spring washers (C) must be installed with cup
of washers facing each other. Do not over-tighten.
1. Install mounting post on machine.
MX8875
2. Insert lower part of latch rod (E) through hole in post.
3. Fasten upper part of latch rod (F) with hex bolt (G)
through latch rod, post hole, flat washer (D), and secure
with a M8 lock nut (A).
4. Fasten hopper top to mounting post with two hex bolts
(B), four spring washers (C) and two M8 lock nuts (A).
5. Raise and lower hopper top several times. Tighten or
loosen hardware to adjust hopper top hinge tightness.
Qty. Description
1 Bagger Support Rod
2 High Lift Blade
1 Hopper Screen
1 Hopper Top
1 Latch Rod
1 Mounting Post
1 Left Grass Bag
1 Right Grass Bag
1 Lower Discharge Chute Assembly
1 Upper Discharge Chute Assembly
Qty. Description
3 Tie Band
1 Drilled Cargo Pin
1 Spring Locking Pin
1 Round Head Bolt
2 Flat Washer
4 M8 x 1.25 Lock Nut
4 Spring Washer
3 Hex Bolt
1 Cargo Mount Bracket
G
B A
H
F
D
C
E
I
A
C
G
D
A
C
B
B
F E