JVC XM-448BK - Manual (Page 14)

12
To check the programmed tracks and their order (In Stop
mode):
Press
4 or ¢ on the remote control unit in Stop mode. The programmed tracks will be
successively displayed in the programmed order. (The track title will be displayed before
the track number, if it is written.)
If you make a mistake in programming (In Stop mode):
Press
7 STOP/CANCEL on the main unit or CANCEL on the cover panel of the remote
control unit in Stop mode to clear the last track. Each press of the button clears the last
track in the program.
Press the button repeatedly until the track you do not want is cleared and then re-program
tracks from that point.
To cancel Program Play mode (In Stop mode):
Main unit:
Press PLAY MODE in Stop mode to select any mode other than Program Play mode.
Remote control unit:
Press PROGRAM in Stop mode to turn off the PROGRAM indicator.
The program contents remain in memory even after the unit has exited from Program Play
mode.
To clear the program:
Press
0 on the main unit or on the remote control unit.
The programmed tracks are cleared then the MD is ejected.
Note: The program contents are cleared from memory when the power cord is unplugged
or in case of power failure.
To play programmed tracks repeatedly:
Combine the program playback and repeat playback to play the programmed tracks
repeatedly.
For the repeat playback, see page 13.
Random playback
Tracks in the MD can be played at random. Random Play may bring you a surprising effect
by playing tracks in a different order every time.
• You can only select Random Play in Stop mode.
1 Load an MD.
See “Continuous playback” on page 8.
2 Select Random Play mode.
Main unit:
Press PLAY MODE until “RANDOM” is shown. Then, the RANDOM indicator lights
up.
Each time PLAY MODE is pressed, the play mode indicators switch as follows:
Number of tracks
PROGRAM
OR
PROGRAM RANDOM Off (Continuous play)
OR
CANCEL
EN01-16.XM-448BK[J]/f 99.1.28, 3:25 PM 12