JAI VIS-CAM System TS-1327EN - Manual (Page 13)

Introduction 1
VIS-CAM System
1.VIS-CAM System Installation Manual
1 Introduction
1.1 Document Overview
This document describes the steps necessary to deploy an installation of the JAI Vehicle Imaging
Subsystem, described as VIS from this point forward.
This manual also contains information about maintenance, troubleshooting and RMA (Return
Material Authorization) procedures.
JAI strongly recommends that the installer read this manual thoroughly, in order to obtain sufficient
knowledge about the VIS equipment, before initiating the actual installation.
1.2 Product overview
The JAI VIS consists of the following components:
• TLS-300 Traffic light sensor.
• The VIS Camera, comprised of an EN- camera with zoom-lens or fixed focal length lens, and an
anti-glare filter, a weatherproof housing with sun shield, heater resistors, interconnection PCB,
and a pan-tilt-roll mounting bracket.
• TNF-31 Flash unit or optional TNC-60 permanent illumination.
• VJP-300 EN-Junction panel with terminal blocks and RJ-45 connectors
and embedded diagnostics Features
• RS485-to-Ethernet Converter
• System interconnection cables
• Optional gigabit Ethernet switch
• Optional 24V DC Power Supply
• Optional Laser Vehicle Trigger
• ENSetup Program
• Installation Documentation