JBM electronic C-130 - Manual (Page 12)

Page -12-
Copyright
©2007 JBM Electronics, Inc.
Step 2: Set the Userid, password and APN
• If you are using a GPRS, Edge, or HSDPA based card, enter the userid, password,
and APN that was provided by your cellular carrier. This information should
have been packaged with your card. If you do not have this information please
contact your carrier account representative or the carrier’ support department
before proceeding.
Note: The userid, password, and APN are case specific. Be certain that you use the
exact information as provided by your carrier.
Step 3: Save and Apply the Configuration
• Click the “Save” button to permanently save the configuration.
• Click the “Apply” button to activate the configuration.
Verify Cellular Connectivity
At this point, if you previously verified that your aircard worked properly in your
PC/laptop, and have been accessing the GAU to configure your JBM gateway via its’
browser, you should be able to access the Internet.
• Open a browser on the PC/Laptop, and attempt to browse the Internet.