JBM electronic C-130 - Manual (Page 4)

Page -4-
Copyright
©2007 JBM Electronics, Inc.
2. Using the instructions that accompanied the card, verify that the card is
properly activated and functioning correctly prior to installing the car into
the JBM Gateway:
•
Install the software that came with the aircard on a laptop.
•
Install the aircard into the laptop.
•
Follow the carrier provided procedures to properly activate the
card, and unlock the card if necessary.
•
Using the browser on the laptop insure that you are able to
browse the Internet.
3. Resolve any and all signal/reception related issues with the aircard
installed in the laptop before installing the card into the JBM Gateway.
4. Gently, insert the Aircard into the PCMCIA slot. Be sure it is firmly
seated.
5. Attach power supply connector to C130 and connect power supply plug to
an AC power outlet.
6. Verify the PWR (yellow) LED is lit to indicate that the unit is receiving
power.
7. Establish access to the unit through Gateway Administration Utility.
Accessing the Graphical Management Interface
Step 1: Connect PC to JBM Gateway
METHOD – 1 ETH0: (Straight Ethernet Port)
• Connect a crossover CAT-5 Ethernet cable between the local PC and the
JBM unit’s ETH0. Verify the link LED is lit. (Straight cable from a
HUB/Switch).
METHOD 2 - ETH1:(Crossed-over Ethernet Port)
• Connect straight CAT-5 Ethernet cable between the local PC and the JBM
unit’s ETH1. Verify the link LED is lit. (Crossover cable for
HUB/Switch).
Port Cable Device
Straight (ETH0) Straight HUB or Switch
Straight (ETH0) Crossed PC
Crossed (ETH1) Straight PC
Crossed (ETH1) Crossed HUB or Switch